|
People ask me how to use the wire winder so here are a few
instructions.
Either clamp your winder to your bench or use screws to permanently
fasten it to your work surface. Place it at a height that will
be comfortable for you to turn the handle. Place it at a height
that will be comfortable for you to turn the handle.
Make a half inch 90 degree bend in the end of your wire. Insert
it along with your mandrel into the chuck of the wire winder.
Spin the barrel towards you until the chuck fits pretty tightly
around your mandrel and wire. Use the jacobs key to make finer
adjustments. Don't over-tighten. (picture below) |
